28
SymSafe/SymSafe Pro
User Manual
7. Select the IP advanced menu.
8. Enter the camera's Streaming/Multicast address into the Multicast field. This address always starts
with the number 230. (230.xxx.xxx.xxx)
Example
•
The DVR IP address is 168.125.115.010
•
The Camera IP address is 168.125.115.025 (both in the camera itself and SymSafe camera menu)
•
The Multicast/Streaming address on both the camera and SymSafe should be 230.125.115.025
•
If you have a second IP camera: The Camera IP Address could be 168.125.115.026 and the Multicast/
Streaming address would still be 230.125.115.025
How to setup a KTD-405 keypad to work with the SymSafe
To setup and connect a KTD-405 keypad and a SymSafe follow the steps below. You will need to refer to the
KTD-405 user manual (part number 1036547D).
1.
Connect a pair of wires from the KTD-405 I/O box to the SymSafe Bus 1/485 port.
•
KTD-405 I/O box pin RS485 (A) to SymSafe Serial I/O Bus 1/485 pin 1 (+).
•
KTD-405 I/O box pin RS485 (B) to SymSafe Serial I/O Bus 1/485 pin 2 (-).
2. Verify the serial communication settings on Bus 1 of the SymSafe;
a. Go to the System/Serial Communication Bus 1 menu and verify the following:
•
Bus 1 Type: RS-0485
•
Protocol:
•
Baud Rate: 9600
•
DVR Addr: 1
3. Enter Zone mode operation on the KTD405 keypad. Please refer to your KTD-405 manual for more
detailed information. Access the KTD-405 zone mode by doing:
a. Hold down the Enter key.
b. Enter programming code: 5-7-9-seq.
c. Change operating mode from Digiplex to Zone mode by the joystick up/down.
d. Press the Fast Forward button.
e. Hold down the Seq button to exit the menu.
f.
You should be in Zone mode.
g. Press the Zone button, then the number 1. This will initiate a connection between the SymSafe and
the KTD-405 keypad.
How to set the IP camera option to a keypad button
The KTD-405 and SymSafe should be connected and operational.
Kalatel