Zero Clearance Adjustable Trim Support, 2" To 10 - Quadra-Fire 5100 ACC Installation Manual

H. Zero Clearance Adjustable Trim Support,
2" to 10"
Part No. 841-0990, size 9" x 45" and
Part No. ADJSPT-12, size 12" x 50"
Included in Kit: (
1) Trim Top, (1) Trim Front, (2) Trim
Sides, Double-Sided Tape (already installed)
Tools Needed:
Phillips Head Screwdriver, Sheet Metal
Shears, Measuring Tape, Gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. Figure 21.1.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips Head screwdriver. Figure
21.2.
3. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from top of trims edge, not bottom. This edge will
be sharp; wear gloves to prevent injury to your hands.
Figure 21.2.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fi ts under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims to
scissors has a particularly powerful bonding adhesive.
Adjustments are extremely diffi cult once trim has adhered
to tape. Do a dry run fi rst without removing paper from
tape.
6. Place cut edge of trim under top lip and into position on
scissors. Place side pieces on fi rst and then front piece.
The front piece overlaps side pieces. NOTE: The trim in
the Flush Mount Kit is one piece.
7. Once you are satisfi ed with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece. Repeat for other side. Install
front trim piece last.
9. There are 3 holes in the back fl ange of the top to secure it
to the wall if necessary. Use the appropriate fastener for
the type of wall material, i.e., brick, Sheetrock, etc.
NOTE: 3/8" ( 9.5mm) thick tile or like material can be cut
to size and fi t under lip of top trim edge for a decorative
touch. Figure 21.3.
10. Thermal protection of 1-1/2 inches (38mm), "k" value of 0.49
and R value of 3.06 under the zero-clearance trim support.
Figure 21.4.
August 25, 2014
EXPLODED VIEW OF SCISSORS
DOUBLE-SIDED TAPE
Figure 21.1
EXPAND SCISSORS TO DESIRED HEIGHT
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
Figure 21.2
Figure 21.3
Figure 21.4
7047-910C
5100 I-ACC
SCREWS ARE CIRCLED
DOUBLE-SIDED TAPE
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
Decorative tile may
be installed
Thermal
Protection
21