Zero Clearance Adjustable Trim Support; Door Handle Assembly; Door Latch Adjustment - Quadra-Fire 4100I-GD-B Manual

Wood insert advanced combustion technology (act)

Hide thumbs Also See for 4100I-GD-B:

User manual (40 pages)

Table Of Contents

Table of Contents

Two sizes: 9"d x 45"w and 12"d x 50"w, both 2" to10" Height Adjustment

Included in Kit: (

1) Trim Top, (1) Trim Front, (2) Trim Sides, Double-Sided Tape (already installed)

Tools Needed:

Phillips Head Screwdriver, Sheet Metal Shears, Measuring Tape, Gloves

1. The 10 screws on each set of scissors will already be loose

when shipped. Figure 16A.

2. Expand scissors to desired height. Tighten screws to hold in

place using Phillips Head screwdriver. Figure 16B.

3. Measure front and side trims to required height to cover scis-

sors and mark pieces for cutting. Cut excess material from

top of trim's edge, not bottom. This edge will be sharp; wear

gloves to prevent injury to your hands. Figure 16B.

4. Using sheet metal shears, cut trim along the marked edge.

The cut edge ﬁ ts under lip of top trim, so it allows for some

variance in your straight edge.

5. The double-sided tape that holds front and side trims to scis-

sors has a powerful bonding adhesive. Adjustments are

extremely difﬁ cult once trim has adhered to tape. Do a dry

run ﬁ rst without removing paper from tape.

6. Place cut edge of trim under top lip and into position on scis-

sors. Place side pieces on ﬁ rst and then front piece. The

front piece overlaps side pieces. NOTE: The trim in the Flush

Mount Kit is one piece.

7. Once you are satisﬁ ed with the positioning, remove trim and

set aside.

8. Remove the paper from double-sided tape that is to accept

trim side. Align side and then press hard against tape to

secure side piece. Repeat for other side. Install front trim

piece last.

NOTE: 3/8" (9.5mm) thick tile or like material can be cut to size and

ﬁ t under lip of top trim edge for a decorative touch. Figure 16C.

DOOR HANDLE ASSEMBLY

Washer

Nut 1/4-20

Door Latch Bracket

Figure 16D

DOOR LATCH ADJUSTMENT

t is important the door gasket has a proper seal. As the gasket compresses or

"seats" during use, it may become necessary to adjust or tighten the door latch.

1. Loosen securing screw (do not remove).

2. Turn adjustment bolts as need for adjustment (in or out) using 7/16" end

wrench.

3. Tighten securing screw to hold adjusted position in place.

Page 16

4100-I ACT WOOD INSERT