Beginning Assembly; Stand - Grizzly G0444 Instruction Manual

Beginning Assembly

This section will cover the basic assembly and
adjustment instructions needed to begin opera-
tion. Complete the assembly in the order provid-
ed in this manual and then read the remaining
portion of the manual before attempting any type
of operation.
Your safety is important! Please follow the
warnings below during this entire section:
!
Sharp edges on metal
parts may cause person-
al injury. Examine the
edges of all metal parts
before handling.
-18-
Loose hair and clothing
could get caught
machinery and cause
serious personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Disconnect power to
the machine during the
entire assembly
process. Failure to do
this may result in seri-
ous personal injury.
Components and Hardware Needed:
Saw ....................................................................1
Stand Legs ........................................................4
Side Supports
• Long Flat ......................................................2
• Long Short ....................................................2
• Long "L" ........................................................2
• Short "L"........................................................2
Carriage Bolts
Hex Bolts
Hex Nuts 5
Flat Washers
Lock Washers
in
Tools Needed:
12mm Wrench or Socket ....................................1
Do not final tighten the stand bolts until all
the

stand

assembled and the saw is rightside-up.
To assemble the stand:
With the help of an assistant, place the saw
1.
face-down on the floor. Note—Lay clean and
staple-free cardboard down to protect the
table surface.
Place the short "L" side supports on the bot-
2.
tom of the saw body (Figure 12). Note—
Make sure the cast logo is facing the front of
the machine.
Cast Logo
Figure 12. L side support installation.
Stand
5 ⁄ "-18 x 5 ⁄ " ..............................40
16 8
5
⁄ "-18 x 1 ........................................4
16
⁄ "-18 ..............................................44
16
5
⁄ " ..............................................48
16
5 ⁄ " ............................................44
16
NOTICE
components
G0444/G0444Z 10" Table Saw
Qty
have been