Place the long "L" side supports over the
3.
ends of the short "L" side supports.
4.
Using a 12mm wrench, secure all four "L"
side supports to the saw body with 4 hex
bolts, 8 flat washers, 4 lock washers, and 4
hex nuts.
5.
Secure each stand leg to the outside of the
"L" side supports with 24 carriage bolts, 24
flat washers, 24 lock washers, and 24 hex
nuts (Figure 13).
Stand Leg
Figure 13. Stand leg installation.
6.
Secure the flat side supports to the stand
legs with 16 carriage bolts, 16 flat washers,
16 lock washers, and 16 hex nuts (Figure
12).
Figure 14. Flat side support installation.
G0444/G0444Z 10" Table Saw
Flat Side Support
Rubber Feet
Components and Hardware Needed:
Rubber Feet........................................................4
1
Hex Nuts
⁄
"-20 ..................................................4
4
Flat Washers
1
⁄
" ................................................4
4
Phillips Head Screws
Tools Needed:
10mm Wrench or Socket ....................................1
Phillips Head Screwdriver ..................................1
To install the rubber feet:
Using a 10mm wrench and a Phillips head
1.
screwdriver, secure each rubber foot to the
stand legs with the Phillips head screws, the
hex nuts, and the flat washers (Figure 15).
Figure 15. Rubber feet installation.
With the help of an assistant, flip the stand
2.
rightside up.
Final tighten all of the stand fasteners.
3.
1
⁄
"-20 x 1" ........................4
4
Qty
-19-