Extension Wings
Components and Hardware Needed:
Extension Wings ................................................2
7
1
Hex Bolts
⁄
"-14 x 1
16
Lock Washers
7
⁄
" ..............................................6
16
7
Flat Washers
⁄
" ................................................6
16
Tools Needed:
17mm Wrench or Socket ....................................1
Straightedge ......................................................1
To install the extension wings:
Align the extension wing holes with the holes
1.
on the cast iron table edges.
Using a 17mm wrench, secure the extension
2.
wings to the cast iron table with the hex bolts,
the lock washers, and the flat washers.
Lay a straightedge across the extension
3.
wings and cast iron table surface.
— If the straightedge lays flat across all
three surfaces, then skip ahead to the
next sub-section.
— If either extension wings tilts down,
loosen it and place a strip of masking tape
along the bottom edge of the table
(Figure 25).
Figure 25. Masking tape location for adjusting
extension table up.
G0444/G0444Z 10" Table Saw
⁄
" ......................................6
4
— If either extension wing tilts up, loosen it
and place a strip of masking tape along
the top edge of the table (Figure 26).
Qty
Figure 26. Masking tape location for adjusting
Tighten the extension wing bolts and repeat
4.
step 3.
5.
Once all three table surfaces are level,
remove the excess masking tape with a
razor blade.
the extension wing down.
-23-