Section 8: Service Adjustments; About Service; Blade Parallelism - Grizzly G0444 Instruction Manual

SECTION 8: SERVICE ADJUSTMENTS

!
Always
power to the machine
before performing ser-
vice adjustments. Failure
to do this may result in
serious personal injury.

About Service

This section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
This section is provided for your convenience—it
is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department at (570) 546-9663.
Similarly, if you are unsure of how to perform any
procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.

Blade Parallelism

To check and adjust blade parallelism:
1. Disconnect the machine from the power
source!!
Raise the blade to its highest position.
2.
Tilt the blade to 90˚. Using an adjustable
3.
square, measure the distance (A) between
the miter slot and the front of the blade as
shown in Figure 53.
G0444/G0444Z 10" Table Saw
disconnect
4.
Figure 54. 90° blade parallelism measurement.
5.
A
Figure 53. 90° blade parallelism measurement.
Rotate the blade 180° and measure the dis-
tance (B) between the miter slot and the
back of the blade as shown in Figure 54.
B
Make note of the difference between the two
measurements on a piece of paper.
!
Front
!
Front
-41-