Grizzly G0444 Instruction Manual page 39

Cutting rabbets with the standard blade:
Note—Cutting rabbets with a standard saw blade
DOES NOT require the use of a sacrificial fence.
Clearly mark the width of the rabbet cut on
1.
the workpiece. Note—Include marks on the
edge of the workpiece to clearly identify the
intended cut while it is laying flat on the saw
table.
2. Raise the blade up to the desired depth of
cut (depth of rabbet channel desired).
Adjust the fence so the blade is aligned with
3.
the inside of your rabbet channel as shown
in Figure 51.
Figure 51. Rabbet cutting.
G0444/G0444Z 10" Table Saw
Turn the saw ON.
4.
When the blade has reached full speed, per-
5.
form a test cut with a scrap piece of wood.
If the cut is satisfactory, repeat the cut with
6.
the final workpiece.
7. Rotate the workpiece as shown in Figure 52.
Figure 52. Rabbet cutting.
8. Perform the second cut to complete the rab-
bet.
-37-