#1
A
#2
Figure 56. 45° blade parallelism measurement.
45˚ Bevel
#1
#2
Figure 57. 45° blade parallelism measurement.
G0444/G0444Z 10" Table Saw
45˚ Bevel
#4
Front
#3
!
#4
Front
B
#3
Tighten down one trunnion bolt a small
3.
!
amount and then move on to each of the oth-
ers, tightening each down the same amount.
Continue to rotate through the bolts, tighten-
4.
ing them a little each time until they are all
secure.
5.
Flip the saw rightside up and repeat steps 2-
6 on page 41.
Once the miter slot is adjusted parallel to the
6.
blade, recheck all measurements and be
sure the table mounting bolts are secure.
7.
Re-attach the blade guard and the fence.
8.
Verify that the blade guard is correctly
aligned with the blade.
If the trunnion assembly is loosened in the
future, make note of the shim locations and
re-assemble accordingly.
NOTICE
-43-