Assembly; Beginning Assembly; Extension Wings - Grizzly G7210 Instruction Manual

14" professional cabinet saw
Hide thumbs Also See for G7210:
Table of Contents

Advertisement

SECTION 4: ASSEMBLY

Beginning Assembly

Some metal parts may
have sharp edges on
them
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.
!
Disconnect power to the
machine when perform-
ing any maintenance,

assembly

ments. Failure to do this
may result in serious
personal injury.
Keep
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Most of your Model G7209/10 has been assem-
bled at the factory, but some parts must be
assembled or installed after delivery. We have
organized the assembly process into steps.
Please follow along in the order presented here.
TOOLS REQUIRED: You will need a high quality
square, a long straightedge, 10mm, 12mm, 14mm
open end wrenches and a 3mm Allen
G7209/10 14'' Table Saw
after
they
are
or
adjust-
loose
clothing
®
wrench.

Extension Wings

Inspect the extension wings for burrs or foreign
material that may inhibit assembly. The mating
edges of the wings and table must be clean,
smooth, and flat. Use a wire brush or file if nec-
essary to clean up the edges.
The table and wings
represent a very heavy
load.
exert yourself while lift-
ing or moving the table
and wings – get assis-
tance.
NOTICE
The right and left wings are not the same.
The left wing has two tapped holes on the
outside edge, the right has a tapped hole on
the front and back edge. If the wings are not
installed in their correct location, the fence
cannot be attached.
1.
Attach the left wing to the table using the
three hex head bolts and flat washers pro-
vided. Adjust the wing reasonably flush with
the table. Do not tighten the bolts.
2.
Attach the right wing to the table using the
three hex head bolts and flat washers pro-
vided. Adjust the wing reasonably flush with
the table. Do not tighten the bolts.
3.
Align the top of the wing flush with the table
top directly above the front bolt, and tighten
the front bolt. The front edge of the extension
wing should also be flush with the front edge
of the table.
4.
Raise or lower the rear of the extension wing
until the middle of the wing is flush with the
table top. Tighten the middle bolt.
DO NOT over-
-13-

Advertisement

Table of Contents
loading

This manual is also suitable for:

G7209

Table of Contents