Tighten the hex nut on the motor bracket to
6.
secure the motor bracket shaft into place.
7.
Slide the motor assembly onto the two shafts
protruding from the back of the saw (Figure
21).
Setscrews
Figure 21. Installed motor assembly.
8.
Using a 4mm Allen wrench, tighten the two
setscrews (Figure 21) in the motor bracket to
secure the motor assembly to the shafts.
Raise the motor assembly and slip the V-belt
9.
over the motor and arbor pulleys (Figure 22).
Lower the motor assembly to tension the V-
belt.
Figure 22. V-belt installation.
-22-
Shafts
!
10. Place a straightedge across the arbor pulley
and the motor pulley. The straightedge
should align across the face of both pulleys
(Figure 23).
Figure 23. V-belt alignment.
— If the pulleys are not aligned, loosen the
bolts tightened in step 4 and reposition
the motor.
11. Secure the V-belt guard to the V-belt plate
with the brass wing nut (Figure 24).
Figure 24. Installed pulley cover.
G0444/G0444Z 10" Table Saw
!