Verification Result Output - Denso GT10B-SB User Manual

7.1.3 Verification result output

(1) Report of match/mismatch status
You can select any of the following report types by using the bar-coded parameter menu or configuration software
(ScannerSetting). Selecting "Disable transmission" reports nothing.
Setting
1 Disable transmission.
2 Enable bar code data transmission.
3 Enable bar code data transmission.
4 Enable OK transmission.
(2) Beeper, indicator LED and vibrator
You can check whether the verification result is a match or mismatch, with the beeper, indicator LED and vibrator.
When the beeper, indicator LED and vibrator are enabled, they act as listed below.
If there is a match:
If there is a mismatch:
(3) Scan lock
The scan lock function locks the scanner on standby if the verification result is a mismatch. You can enable or disable
this function with the bar-coded parameter menu or configuration software (ScannerSetting).
Once the scanner is locked, it switches to standby regardless of the current trigger switch control selected. The scanner
remains on standby even if the trigger switch is pressed or a ready-to-scan command (R, READON or LON) is
received.
Pressing the magic key or reloading the battery cartridge releases the scan lock.
Note: In the data verification mode, the magic key is used to register a master bar code, not used to break the
®
Bluetooth wireless link. To break the link, scan the "Break Bluetooth
the scanner, as a master, is searching for a connection target or it is, as a slave, waiting for a master to connect, the
magic key can break the Bluetooth
code.
Note: Removing the battery cartridge clears master data stored in the scanner.
Note: In any of the following cases, the scan lock is disabled regardless of the current setting.
- When the "End operation" is selected
- When the Bluetooth
selected
Note: Breaking and connecting the Bluetooth
data stored releases the scan lock.
If there is a match:
Beeper
Emits a short beep.
Emits a long beep.
®
wireless link. See Section 2.3 for the "Break Bluetooth
®
wireless link is broken, except when the "Scan w/ Bluetooth
Disable transmission.
Disable transmission.
Enable NG transmission.
Enable NG transmission.
Indicator LED
Lights in blue.
Lights in red.
®
wireless link does not release the scan lock. Clearing the master
22
If there is a mismatch:
Vibrator
"OK" vibrations "NG" vibrations
Operates.
--
®
wireless link" bar code. Note that when
®
wireless link broken" is
--
Operates.
®
wireless link" bar