Table of Contents
Advertisement
9.2
Indicator LED
The indicator LED lights or flashes in blue, green, red or orange to indicate the scanner status as described below.
Lights in blue when:
• a read of a bar code is successfully complete (Note that when the auto sensing mode switching function* is enabled,
the indicator LED lights in green.),
• the "Start setting" or "End setting" bar code symbol is read from the bar-coded parameter menu (given in Chapters
13 and 14),
• bar code data read matches the master data in the data verification mode,
• the auto sensing mode switching function* has switched the scanner to the currently selected trigger switch
operating mode, or
• switched to the trigger switch operating mode using the continuous reading mode switching function.
Flashes blue when:
• the scanner, as a master, is searching for a slave device for Bluetooth
• the scanner, as a slave, is waiting for a master to initiate Bluetooth
Lights in green when:
• a processing started by magic key control has completed,
• the scanner is ready to register master data in the data verification mode,
• the scanner has read a bar code (except a master bar code for data verification) successfully with the auto sensing
mode switching function* being enabled, or
®
• the Bluetooth
wireless link is ready for use.
Lights in red when:
• a check digit error has occurred,
• a bar code read has the wrong number of digits,
• bar code data read does not match the master data in the data verification mode,
• a master bar code read has the wrong number of digits in registration of master data,
• the data retransfer function failed to transfer data,
• an editing error has occurred in the specified data editing, resulting in no transfer,
• the scanner failed to establish the Bluetooth
• pairing has failed in Bluetooth
Flashes red when:
• no master data has been registered in the data verification mode,
• the trigger switch was pressed with the "End operation" selected, or
• the trigger switch was pressed with the Bluetooth
Lights in orange when:
• the auto sensing mode switching function* has switched the scanner to the auto sensing mode, or
• switched to the continuous reading mode using the continuous reading mode switching function.
Flashes orange when:
• the charge of the battery cartridge has lowered.
*For the auto sensing mode switching function assigned to the magic key, refer to Chapter 6.
®
wireless link, or
®
authentication.
®
wireless link broken.
®
wireless connection or
®
wireless connection.
37
Advertisement
Table of Contents
