Mantel And Wall Projections - Heat & Glo XLR-PLUS-N-AU Owner's Manual

D. Mantel and Wall Projections
WARNING! Risk of Fire! Comply with all minimum clear-
ances to combustibles as specifi ed. Framing or fi nishing
material closer than the minimums listed must be construct-
ed entirely of noncombustible materials (i.e., steel studs,
concrete board, etc).
Mantels (Combustible/Non-Combustible)
10 mm
Thick Wall
Sheathing
360 mm
Figure 5.3 Clearances To Combustible Mantels Or Other
Combustibles Above Appliance
Note: For non-combustible fi replace fi nish material (marble,
stone, etc) specifi cations refer to Section 13.
Mantel Leg (Combustible/Non-Combustible)
TOP VIEW
80 mm
MINIMUM
Figure 5.4 Mantel Leg or Wall Projections
(Acceptable on both sides of opening)
20
300 mm
MAX.
MEASUREMENT
FROM TOP OF
FIREPLACE
MIN.
OPENING
UNLIMITED
Heat & Glo • XLR-PLUS-N-AU, XLR-PLUS-PB-AU • 2264-900 Rev. D • 6/11
Front Side Finishing Detail
37 mm
Figure 5.5 Front Side Finishing Detail
890 mm
25 mm
25 mm
AIR SPACE
Figure 5.6 Non-Combustible Zone
Note: AIR SPACE denoted in Figure 5.6 is defi ned by the
nailing tabs and top metal standoffs.
30 mm
FRAMING
10 mm BUILDING MATERIAL
10 mm THICK
WALL SHEATHING
NON-COMBUSTIBLE
BOARD SHIPPED
WITH APPLIANCE