Error Messages - Gerber InkJet Printer Owner's Manual

Chapter 8
Troubleshooting
Common Printer Messages
Slide UV Shield next to the
material
Slide UV Shield to its
parked position
Starting Clean Heads ...
Starting Clear Ink Line ...
Starting End of Day Clean...
Starting Fill Ink Line...
Starting Inspect Nozzles ...
Starting Purge ...
Step Blending is ON/OFF
Table vacuum is ON
Table vacuum is OFF
Updating Front Panel
Firmware
Waste Ink Tray must be
installed

Error Messages

The following error messages may appear on the Gerber CAT|UV display indicating a
problem. Follow the recommended action to correct the error. If the error persists, seek technical
assistance from an authorized dealer or Gerber Service.
Error Message
Ballast Board Not
Found
BLACK Empty
Cannot fill ink
P83173A RevA
7/19/10
Description
UV Shield is required for material thicker than 0.040". Grasp the UV
shield handle and slide the shield until the right edge of the handle is
aligned with the right edge of the material.
UV shield is not required for material thinner than 0.04". Grasp handle
and slide all the way to the right into the park position.
Clean Heads procedure has begun.
Clear ink line sequence has begun.
End of Day Clean sequence has begun.
Ink line fill sequence has begun.
Inspecting nozzles sequence has begun.
Purging sequence has begun.
Step Blending status is displayed.
Displays to indicate the status of the table vacuum.
Displays to indicate the status of the table vacuum.
Displays at start-up when the front panel board is being updated.
Printer power must remain on or errors will occur. Wait until update is
complete.
Replace waste ink drip tray if it has been removed for cleaning.
Description
Ballast Board not found at power-
up.
Black ink pouch is empty.
Ink filling cannot be done due to a
problem in the ink system.
Recommended Action
Cycle power. If problem persists, seek
technical assistance.
Replace Black ink pouch.
This message occurs for various
reasons including: failure to set ink
vacuum pressure, waste ink tray not
installed, an empty ink line, or a
problem in another ink component.
Check the Message Log and correct
the condition. If problem persists seek
162