Table of Contents
Advertisement
Chapter 7:
Troubleshooting
Responding to control panel messages
The following table lists typical control panel messages that may appear while using the
GERBER EDGE FX and provides an explanation of each and a suggested response if one is
required.
Message
READY
OFFLINE
PAUSED
WARMING UP *******
PROCESSING DATA
PRINTING
Homing...
Cancel Job?
Check Material!
Check Foil!
Check Cassette !
Description
The GERBER EDGE FX is online and ready to print.
The GERBER EDGE FX is offline. Job data will not be received.
However, the unit is visible on the network. The printer must also be
Offline to use the slew keys or update the firmware.
A job was printing and the GERBER EDGE FX is paused. Press
Online to resume printing. The printer can also be placed in this state
when running a diagnostic test.
The thermal print head (TPH) is warming up prior to printing a job.
The job can begin when the print head reaches the proper operating
temperature.
The GERBER EDGE FX is processing job data.
The GERBER EDGE FX is printing a job.
Either the X-axis or Z-axis is locating the home position.
Press F1, YES to cancel the current job.
The material isn't loaded. Load material before continuing with job.
The job is resumed when the F1, RETRY key is pressed.
The end of the foil has been reached (or the foil has broken). Insert
another foil cassette. If the foil is broken, then it can be repaired with
tape before re-inserting the cassette. The job is resumed when the F1,
RETRY key is pressed.
The cassette is not loaded. Load a foil cassette before continuing with
job. The job is resumed when the F1, RETRY key is pressed.
63
Hide quick links:
Advertisement
Table of Contents
