Table of Contents
Advertisement
The message is not repeated unless you insert a tool and run a job, then
remove the tool and again attempt to start a job without it.
Wide material
If the middle pinch wheel is in the center of the material, the middle
pinch wheel pressure lever should be in the down position. If this
message appears, the lever is in the wrong position.
♦
Flip the position of the lever, which is located behind the middle pinch
wheel.
♦
Press any key to retry.
Error messages
The ODYSSEY XP plotter is programmed to detect certain mechanical
and electrical error conditions at power-up or during operation. A
repetitive long-short, long-short beeping pattern means that an error has
been detected. When an error condition occurs, the plotter may turn off
power to the motors.
If you require assistance, please contact your Gerber distributor or
contact the Gerber Field Service Department at:
800-828-5406 (USA and Canada)
860-643-1515 (International)
860-648-8376 (fax)
e-mail: gsptech@gspinc.com
www.gspinc.com
57
Hide quick links:
Advertisement
Table of Contents
