Error Conditions; Error Signals - Gerber HS750 Plus User Manual

ERROR CONDITIONS

The HS750
mechanical/electrical error conditions at power-up or during
operation. When an error condition occurs, the plotter may turn off
power to the servo motors. There will be continuous beeping and
flashing lights.

Error Signals

There are three kinds of error signals:
! 3-second steady tone, lights on (running job)
The plotter continues but the job is clipped (parts are not
plotted). This happens when the job has exceeded the
boundaries of the plotter. There is no recovery and the job
must be sent again with a starting position that allows the job
to fit within the plotting area.
! 3-second steady tone, lights on (no running job, slewing
only, part of plotter jarred)
One or more axes are shut down because of excessive lag.
For recovery, press the RESET button to turn the axes on
again. The Z, theta, and Y axes will rehome their position. If a
job was pending, it must be resent.
! Continuous beep and flashing lights
With this warning a procedure has been established to
determine which error condition may have occurred. See the
next page for determining error numbers.
plus
is programmed to detect certain
51