Reset; Whites Setting; White Calibration - Chauvet COLORado Zoom TOUR User Manual

Reset

Default Values

Whites Setting

White Calibration

COLORado™ Zoom Tour User Manual Rev. 07
This setting allows the user to reset the COLORado™ Zoom Tour to its default values,
including the custom programs.
1. Go to SET.
2. Select REST.
3. When PASS shows, press <ENTER>.
4. Enter the master access password as shown in Control Panel Lock.
5. Wait for the reset process to finish.
Parameter
STAT
AUTO
ADDR
RUN
PERS
DIM
This setting allows the user to select and edit the temperature of the white colors used in
channel 6 (Macros) when in the TOUR mode. It also allows the user to define the
maximum RGB values when RGB to White (RGB.W) is active.
1. Go to CAL1.
2. Select a white color (WH. 1~11).
3. Select a color (R., G., B., or W.).
4. Select a color value (0~255).
5. Repeat for the other colors.
This setting allows the user to select the white color shown by the COLORado™ Zoom
Tour when the color setting is RGBW and the DMX controller's Red, Green, and Blue
faders are set to 255.
1. Go to CAL2.
2. Select a color (R., G., or B.).
3. Select a color value (0~255).
4. Repeat for the other colors
When selecting CAL2 > RGBW you will only be able to define the values of R. (red),
G. (green), and B. (blue).
The values of R. (red), G. (green), and B. (blue) configured from CAL2 > RGBW will
define the color temperature shown when the RGB faders are set to 255 if SET >
COLO > RGBW is active.
Default Value Parameter
R/G/B.000 COLO
AT.01 EDIT
D.001 CAL1
DMX CAL2
TOUR KEY
DIM4
Operation
Default Value
UC
PR.01/SC.01
WH.01
R/G/B.255
OFF
-13-