Control Panel Lock; Program Upload - Chauvet COLORado Zoom TOUR User Manual

Operation
Control Panel
Lock

Program Upload

-12-
This setting allows the user to activate or disable the control panel lock, which keeps non-
authorized personnel from changing the product's settings.
1. Go to KEY.
2. Select ON or OFF.
When the control panel lock is active, the product will prompt the user to enter the
password after 30 seconds of control panel inactivity or after turning on the product.
After being prompted to enter the password:
Press <UP>, <DOWN>, <UP>, <DOWN>, and <ENTER>.
This option allows the user to copy the custom programs of one COLORado™ Zoom Tour
unit onto other COLORado™ Zoom Tour units by using the Master/Slave method.
1. Configure and connect the units in a Master/Slave arrangement, where the
master unit has the custom programs you want to transfer to the slave units.
2. At the master unit, go to SET.
3. Select UPLD.
4. When PASS shows, press <ENTER>.
5. Enter the master access password as shown in Control Panel Lock.
6. When SEND shows, press <ENTER> to start the upload.
7. Wait for the upload process to finish (the display will show END/MAIN) before
continuing or turning the units off.
The master and slave units will light up to provide the status of the process, as
follows:
 Yellow indicates that the upload process is running.
 Green indicates that the upload process completed successfully.
 Red indicates that the upload process failed due to an error. Recheck all cable
connections and restart the process. If the issue persists, contact Chauvet
Technical Support.
DO NOT upload the program from a COLORado™ Zoom Tour to a different product.
You could render the other unit inoperative.
COLORado™ Zoom Tour User Manual Rev. 07