Master/Slave; Color Settings; Dimmer Curves - Chauvet COLORado Zoom TOUR User Manual

Master/Slave

Color Settings

Dimmer Curves

COLORado™ Zoom Tour User Manual Rev. 07
The Master/Slave mode allows a group of COLORado™ Zoom Tours (the slave units) to
simultaneously duplicate the output of another COLORado™ Zoom Tour (the master unit)
without a DMX controller.
1. Set each of the slave units:
a. Go to RUN.
b. Select SLAV.
2. Set the master unit:
a. Set the running mode to DMX as explained in DMX Control.
b. Select an auto or custom program as explained in Auto Programs, or a
static mix of colors.
 The master unit is the one that runs a program, whether Auto, Custom, or Static
mode.
 Do not connect a DMX controller to the units configured for Master/Slave
operation.
 The master unit should be the first in the DMX string.
The COLOR setting determines how the COLORado™ Zoom Tour generates the white
color based on various RGB settings.
1. Go to SET.
2. Select COLO.
3. Select OFF, RGBW, or UC.
OFF: When the RGB faders are all set to 255, the output is maximum, although
the resulting white color may not be balanced.
RGBW: When the RGB faders are all set to 255, the resulting output is defined by
the configured white color (see White s Settings).
UC: When the RGB faders are all set to 255, the output matches that of less
efficient products (Universal Color).
This setting determines how fast the output of the COLORado™ Zoom Tour changes when
the operator modifies the values of the Red, Green, Blue, White, and Dimmer faders. This
setting gives the user four different options to simulate the dimming curve of an
incandescent lighting product.
1. Go to SET.
2. Select DIM.
3. Select a dimmer curve (OFF, DIM1, DIM2, DIM3, or DIM4).
OFF: The output is proportional (linear) to the Dimmer and RGBW channel
values.
DIM1~4: The output follows the Dimmer and RGBW channel values based on the
corresponding dimmer curve. DIM1 is the fastest and DIM4 is the slowest.
Operation
-11-