Operation
WDMX Reset
To reset the WDMX connection and allow the Maverick Force 1 Spot to connect to a WDMX transmitter:
1. Go to the Settings main level.
2. Select the WDMX Reset option.
3. Select from NO (do not reset) or YES (reset the WDMX connection).
Follow instructions in the manual or guide for the WDMX controller being used to connect
it to the receiver in the Maverick Force 1 Spot.
Display Backlight Timer
To set the length of time before an inactive display will turn off:
1. Go to the Settings main level.
2. Select the Backlight Timer option.
3. Select the length of the backlight timer, from 30S (30 seconds), 1M (1 minute), 5M (5 minutes), or
ON (always on).
Loss of Data
To set how the product reacts to a loss in control signal data:
1. Go to the Settings main level.
2. Select the Loss of Data option.
3. Select from Hold (holds the last values received before signal loss) or Close (blacks out the product).
Fan Mode
To set the fan speed mode:
1. Go to the Settings main level.
2. Select the Fans option.
3. Select the fan mode, from Auto (fan speed adjusts to product temperature), Full (fan speed at
maximum), or ECO (quiet mode).
Dimmer Curve
To set the dimmer curve:
1. Go to the Settings main level.
2. Select the Dimmer Curve option.
3. Select the dimmer curve, from Linear, Square, I Squa, or SCurve.
Pulse Width Modulation
To adjust the frequency of the pulse width modulation:
1. Go to the Settings main level.
2. Select the PWM Option option.
3. Select the frequency, from 600Hz, 1200Hz, 4000Hz, 6000Hz, or 15000Hz.
LED Power
To set the maximum LED output:
1. Go to the Settings main level.
2. Select the LED Power option.
3. Set the power from 64–255.
Minimum Zoom Focus
To enable or disable the minimum zoom focus function:
1. Go to the Settings main level.
2. Select the Min. Zoom Focus option.
3. Select No (disables minimum zoom focus) or Yes (enables minimum zoom focus).
Preset Selection
To select a preset configuration of menu options:
1. Go to the Settings main level.
2. Select the Preset Select option.
3. Select from PRESET A (default), PRESET B, or PRESET C.
•
Changes to settings automatically save to the currently selected preset option.
•
If no preset option has been selected, changes to settings save to PRESET A.
•
After selecting a preset option, the product will restart.
Maverick Force 1 Spot User Manual Rev. 7
21