Table of Contents
Advertisement
4. Press
on the back of the
TEST
motion detector.
The console chimes, and the first
available zone indicator lights to
show the console has logged in
the motion detector.
If you do not hear a chime, press
with a pencil, then press
CODE
again.
TEST
5. Looking at the back of the motion
detector, set the switch on the left
side to
.
1
6. Place one of the supplied num-
bered stickers on the motion
detector to show its zone number.
7. Leave the console's switch set to
to install other accesso-
INSTALL
ries.
8. Replace the battery compartment
cover.
INSTALLING THE LAMP
MODULE
When the alarm trips, lamps connect-
ed to lamp modules flash on and off for
the duration of the alarm. After 4 min-
utes (or when you disarm the alarm),
the lamps stop flashing and remain on.
If you arm the system with an exit de-
lay, lamp modules that are set to the
same House and Unit code as the con-
sole turn on during the exit countdown
time.
You can also control lamp modules set
to this code from
LIGHT ON
on the keychain remote control, or
OFF
using
SECURITY LIGHT
held remote.
Follow these steps to install a lamp
module.
1. Plug a lamp into the supplied lamp
module and plug the module into
an AC outlet that is on the same
electrical circuit as the console.
Be sure the lamp's on/off switch is
on.
2. Set the lamp module's House and
Unit code dials to the same letter
as the console and the same
number (1, 2, 3, or 4) as the but-
ton that will control it.
and
LIGHT
on the hand-
15
Hide quick links:
Advertisement
Table of Contents
