Radio Shack 49-1010 User Manual

Campus Security Kit
doorstop alarm
trigger anchor
UV proof window decals (2)
keychain alarm with light
double-sided
adhesive tape (1)
Thank you for purchasing your Campus
Security Kit from RadioShack.
what's included
doorstop alarm
window alarm UV proof window decals (2)
double-sided adhesive tape (1)
Please read this user's guide before
installing, setting up and using your new product
www.radioshack.com
using your doorstop alarm
49-1010
The door stop alarm is for indoor use only.
window alarm
ON/OFF
2. Insert the alarm
at the base of your
door, making sure
the non-skid pad
on the bottom
of the alarm is in
firm contact with
the floor. When the door is opened,
the alarm's metal plate is depressed,
which presses down the trigger
anchor and sounds the alarm.
3. To silence the doorstop alarm, turn it
OFF.
4. Press down on the metal wedge so
keychain alarm
that it is positioned where it will
depress the trigger anchor.
Your window alarm comes with four LR44
button-cell batteries installed. Before use,
1. Remove battery test the batteries as follows:
compartment
cover, and insert 1. Slide to Lo or Hi.
one 9V battery (not
supplied) as 2. Push this button. If
shown. Slide
ON/OFF to ON.
3. Slide off the battery
1. Mount your window alarm indoors, on
2. Apply the supplied adhesive tape onto
3. Slide to Hi or Lo to arm. Hi provides
4. Apply the UV proof window decal on
5. Slide to OFF to disarm the unit.
using your window alarm

the red LED lights,
the batteries are
good. If the LED does
not light, replace the
cover to replace the
batteries.
Mounting your Alarm
a window pane.
a window pane, with the side labeled
"ACTIVE" facing outside for external
visibility. Then, firmly press the window
alarm onto the adhesive tape.
more sensitivity for a larger area; Lo is
suitable for use in a smaller area.
the window.
