Table of Contents
Advertisement
49-840in.fm Page 12 Thursday, August 19, 1999 10:47 AM
3. Use pliers to squeeze down the
tapping blade.
4. Close the insulated cover so it
snaps.
MOUNTING THE MAIN
MODULE
Select a location for the main module
where it is completely concealed and
difficult to access after installation. An
ideal location is usually under and be-
hind the vehicle's dashboard on the
firewall. Use two of the supplied wire
ties to secure the main module under
the dash.
12
INSTALLING THE
STATUS INDICATOR
Use the supplied mounting bracket to
hold the indicator or drill a hole in the
dash. Follow these steps to install the
indicator.
1. To use the supplied mounting
bracket, use denatured alcohol
to clean the surface and let it dry
completely. Peel the backing off
of one side of the double-sided
tape and press it onto the bottom
of the bracket. Then peel the
adhesive backing from the other
side of the tape and press the
bracket onto the dash.
To mount the indicator in the
dash, drill a
desired location. The surface
should be less than
2. Press the supplied grommet into
the mounting hole from the front
of the surface.
3. Press the indicator into the grom-
ment from behind the surface.
4. Plug the indicator's plug into the
matching jack on the system.
5. Use a supplied wire tie to secure
the wire out of the way.
Need Help? Call 1-800-598-2527
1
/
-inch hole at the
4
/
-inch thick.
1
8
Grommet
Indicator
Advertisement
Table of Contents
