Testing The System - Radio Shack 49-2551A Owner's Manual

TESTING THE SYSTEM

After you have completed all of the
quick installation procedures, follow
these steps to test the system.
Note: To avoid unnecessarily alarming
your neighbors, tell them you are test-
ing the system.
1. Set the
INSTALL/RUN 1/RUN 2
switch on the console to
REC/BUSY lights for 15 seconds.
2. Place each wireless sensor trans-
mitter's magnet next to its mag-
netic switch with the arrows
pointing toward each other.
3. Place the motion detector on a
counter top within 100 feet of the
console.
16
4. Move a wireless sensor transmit-
ter's magnet away from the mag-
netic switch.
When the system is not armed
and set to
emits a chime every time some-
one opens a door or window. The
system does not chime when it is
set to
Replace the magnet next to the
RUN 2.
magnetic switch.
5. Press
and then move the magnet away
from the magnetic switch again.
The alarm sounds and the lamp
connected to the lamp module
flashes on and off. Press
to turn off the alarm, and
OFF
the magnet next to the magnetic
switch.
6. Press
control, then walk across the path
of the motion detector's lens. The
alarm sounds and the lamp con-
nected to the lamp module flashes
on and off. Press
off the alarm. The console chimes
twice. Press
off the lamp.
, the console
RUN2
.
RUN 1
on a remote control,
ARM
DISARM
to turn off the lamp. Replace
on the remote
ARM AWAY
DISARM
LIGHTS OFF
LIGHTS
to turn
to turn