Initializing The Wireless Sensor Transmitters - Radio Shack 49-2551A Owner's Manual

Note: If you do not hear a chime,
press the button beneath the
remote control's label with a pen-
cil. Then repeat this step.
6. Leave the console's switch set to
to install other accesso-
INSTALL
ries.
7. Replace the battery compartment
cover.
Note: You can add any combination of
Plug 'n Power keychains (Cat. No. 49-
2591) or handheld remote controls
(Cat. No. 49-2551T), up to a total of
eight.
INITIALIZING THE
WIRELESS SENSOR
TRANSMITTERS
Follow these steps to initialize each
wireless sensor transmitter you plan to
use with your system.
1. Lift open the-
transmitter's bat-
tery compartment
cover. Hold down
located to
TEST,
the right of the
compartment,
long enough to
fully discharge
the sensor (about
3 seconds).
2. Install two AA alkaline batteries in
the compartment according to the
polarity symbols (+ and –) marked
inside.
3. Be sure the console's
switch is set to
RUN 1/RUN 2
.
INSTALL
4. Press
TEST on the transmitter
about 1 second. The indicator
blinks twice to generate a new
code.
Note: The indicator flashes rap-
idly during a violation or after you
press . When the batteries'
TEST
voltage drops below around 2.7V,
the indicator flashes twice when
is pressed to indicate that
TEST
the batteries are weak.
INSTALL/
for
13