Assigning Security Codes; Reassigning Security Codes - Radio Shack 49-2551A Owner's Manual

ASSIGNING SECURITY
CODES
A security zone is an area of protection
covered by a single wireless sensor
transmitter, motion detector, or other
sensing/transmitting device. Your se-
curity console monitors up to 16 zones
and alerts you if there is a violation
(see "Zone Indicators" on Page 27).
When you initialize your security sys-
tem's sensors, the console assigns a
zone number to the sensor (see "Ini-
tializing the Wireless Sensor Transmit-
ters" on Page 13). The system
includes numbered stickers you attach
to each sensor to show its zone num-
ber. For your reference, make a record
of which area of your home a zone
covers. For example, using the floor-
plan you drew, you could mark the
front door as "Zone 1."
REASSIGNING
SECURITY CODES
If you want to remove one accessory,
reassign an accessory to a zone cur-
rently in use, or add an accessory
when all zones are assigned, you must
completely reinitialize the entire sys-
tem.
To reinitialize the system, unplug the
console and remove its battery back-
up. The console loses all stored codes.
Then reinitialize all remote controls,
wireless sensor transmitters, and mo-
tion detectors, assigning each acces-
sory to the desired zone.
9