Using The Panic Alarm; Zone Indicators - Radio Shack 49-2551A Owner's Manual

Notes:
• The supplied motion detector
(Cat. No. 49-2589) only operates
in the mode.
INSTANT
If you want to use the exit/entry
delay feature,
another motion detector (Cat. No.
61-2614) instead of the one sup-
plied with this system. However,
the feature might not
ARM HOME
work.
• You must set the switch inside the
wireless sensor transmitter's bat-
tery compartment to
for it to arm in the delay mode.
When set to
MIN
immediately arms, regardless of
whether the handheld remote con-
trol is set to
DELAY
• The button on the console
ARM
automatically arms the system in
the mode.
DELAY
• The keychain remote control only
arms the system in the
mode.
• Other separately
remote controls might arm the
system only in either the
mode. See the remote
INSTANT
control's owner's manual.
you can use
in order
MAX
, the sensor
or .
INSTANT
INSTANT
purchased
or
DELAY
USING THE PANIC
ALARM
Pressing on the handheld re-
PANIC
mote control, or
ARM
the same time on the keychain remote
control, causes the console's alarm to
sound, even if the system is not armed.
Note: The telephone dialer does not
dial out unless the system is armed.

ZONE INDICATORS

All sensors and motion detectors re-
port to the console about every 90 min-
utes. If the console does not receive a
signal from a sensor within 4 hours, it
reports a problem with that sensor by
slowly flashing its zone indicator.
The console's zone status indicators
show four conditions for Zones 1–8.
and at
DISARM
27