Table of Contents
Advertisement
49-2570.fm Page 17 Wednesday, August 18, 1999 3:59 PM
INSTALLING THE LAMP
MODULE
When the alarm trips, lamps connect-
ed to lamp modules flash on and off for
the duration of the alarm. After 4 min-
utes (or when you disarm the alarm),
the lamps stop flashing and remain on.
If you arm the system with an exit de-
lay, lamp modules set to the same
House and Unit Code as the console
turn on during the exit countdown.
You can also control lamp modules set
to this code using
SECURITY LIGHT
the handheld remote.
Follow these steps to install a lamp
module.
1. Plug a lamp into the supplied lamp
module and plug the module into
an AC outlet that is on the same
electrical circuit as the console.
Replace with the actual illustration
on
Note: Do not plug an appliance or
fluorescent lamp into the supplied
module.
2. Be sure the lamp's switch is on.
3. Set the module's House and Unit
Code dials to the same codes you
selected when you set up service.
17
Advertisement
Table of Contents
