Initializing/Registering Your Keychain Remote; Initializing Your Door/Window Sensors; Registering Your Door/Window Sensors - Radio Shack 49-1000 User Manual

Beyond the Basics
initializing your keychain remote
Press and hold the arm button on your
Keychain Remote for three to four seconds, and
then release it. This initializes the remote and picks a
random code that is used when it is registered with
your Security Console.
registering your keychain remote with your
Security Console
 Press either of the Menu
"ENTER PIN" in the top line. When you enter your PIN, *
displays for each number entered.
 Press ok when you see "INSTALL" on the display.
 Press any button on your Keychain remote. The Console
acknowledges that it has been registered by beeping and
displaying "RMOT 1 SET, RMOT 2 SET," etc. as you install more
remotes.
 Repeat this for each Keychain Remote you want to register.
 Repeatedly press clear to back out of the menu. To confirm
your selection, press 1 for YES or 2 for NO. Pressing 1 takes
you back to the HOME CONTROL screen. Pressing 2 takes you
up one menu level.

initializing your Door/Window Sensors

 To open the battery compartment, remove the screw
and install two AAA alkaline batteries, matching the
polarity (+ and -) marked inside.
 Set the DELAY switch inside your Sensor to MAX (left)
for doors, or MIN (right) for windows.
 Press and hold the button inside your sensor for
three to four seconds, and then release it. This
initializes the sensor and picks a random code
that is used when it is registered with your
Security Console.
 Replace the battery compartment cover and
place the magnet next to the sensor, aligning
the arrows.
/
buttons. The display shows
8
Arm

