Lan Cable Connection; Connecting The Alarm Signal Terminal - JVC VN-V686U Instructions Manual

Connection/Installation

LAN Cable Connection

Connect the camera to a hub or computer using a
LAN cable.
Cable to use
● Shield (STP) cable
● Make use of a Category 5 (or higher) cable
when 100BASE-TX is used.
When connecting to a hub
Make use of a straight cable.
When connecting to a computer
Make use of a cross cable.
[10BASE-T/100BASE-TX]
LAN cable connection
terminal
Note:
● However, cross cables cannot be used with
some computer models. When connecting VN-
V686U directly to a computer, check the
computer's LAN specifications in advance.
Connecting the alarm signal
terminal
Connect the alarm signal cable to external devices,
such as a sensor or buzzer.
Cable to use
● Length of 50 m or shorter
● UL1007, UL1015 or equivalent products
● AWG#22 to AWG#18 or equivalent products
A
Loosen screws on both sides of the
terminal block with a flathead screwdriver
and remove the terminal block as shown
in the diagram below.
:
Memo
● Inserting the tip of the screwdriver into the slit of
the terminal block will remove the terminal block
easily.
B
Peel off about 4 mm of the alarm signal
cable covering and insert into the
terminal.
C
Turn the screws at the side and secure the
alarm signal cable.
D
When the alarm signal cable is secured,
return the terminal block that was
removed in A to its original position.
C
D
B
Note:
● Noises from an external source may cause the
camera to malfunction even when the cable
used is within 50 m. In this case, move the cable
away from the noise source.
Alarm signal
terminal
A
A