JVC VN-V686U Instructions Manual page 98

Settings and operation of Built-in Viewer
JPEG Viewer (continued)
JPEG Viewer Configuration (continued)
BStream Settings (continued)
Multicast IP Address
Multicast Port
C
Folder Name
D
Operator Password
E
Cancel
F
OK
:
Memo
● The settings of Built-in Viewer are stored in the file named Cookie.
This setting screen is used to set Built-in Viewer as a software on the computer, and does not apply to
settings of the VN-V686U unit.
When settings are changed, press the [OK] button to exit and restart the viewer.
:
Memo
Searching and deleting cookie files
● Open [Tool]-[Internet Options]-[Advanced] of the Internet Explorer, and press the [Settings] button under
[Temporary Internet Files]. A new [Settings] window will appear. Press the [View Files] button in this
window. The [Temporary Internet Files] window opens up and a list of files will be displayed. The file
named cgi-bin in this list is the Cookie for Built-in Viewer.
● Deleting this file deletes the view settings, and the viewer will be initialized during the next startup.
You can change the multicast IP address.
The default IP address setting is 225.0.1.1 .
You can change the multicast port number.
The default port number setting is 49152 .
:
Memo
● This is enabled when Start is selected for the [JPEG Control] item
on the [Streaming] page.
● Specify the same value as the parameter that is set on the [Streaming]
page of VN-V686U. (A Page 71)
For specifying the name of the folder in which the captured files are
stored. (When the viewer is installed: VN-V686)
[Operator Password] is required when controlling VN-V686U via PTZ or
when retrieving position titles from VN-V686U. Enter the [Operator
Password] to use the PTZ controller screen or to display position titles.
When [Operator Password] has been entered under other settings, it will
be displayed as ●●●●●●●●.
(A Page 34 [Enter user name and password])
Cancels the changed settings and closes the setting screen.
Saves the changed settings.
Click the [OK] button to enable the new settings and restart Built-in Viewer
after closing the setting window.