JVC VN-V686U Instructions Manual page 77

A
Restart
B
All Settings
[Initialize]
C
Update
D
Auto Cleaning
E
Auto Cleanig Time
Reboots the camera. (It takes a few minutes for the camera to reboot.)
Restores all settings to their default values and reboots the unit. (It takes about
one minute for the camera to initialize and reboot.)
Passwords will also be initialized. Built-in clock of VN-V686U will not be affected.
JPEG/MPEG4 transmission and all other services that are running will be
discontinued.
Upgrades the firmware version of VN-V686U and reboots the unit.
Select the update target from [Streaming Manager], [PTZ Controller] or [Image
Processor].
The settings of VN-V686U will be saved. Copy the new firmware file to the
computer on which Internet Explorer is used, and specify this file using the
[Browse...] button. Press the [Update] button to start the update. JPEG/MPEG4
transmission and all others services that are running will be discontinued. The
update process may take several minutes.
A message will be displayed on the Internet Explorer when update is
successfully completed.
Note:
● Do not turn off the power when update is in progress or during reboot after
update is complete. Turning off the power of the camera may cause it to
malfunction.
This item sets whether to automatically clean the power and signal transmission
components.
Note:
● When the camera has stopped at the pan position for more than 7 days, it will
pan at the specified time and perform cleaning automatically.
This item sets the time to start cleaning.
To change the setting, enter the time and click the [Apply] button.
[Setting value:0-23 h, 0-59 m]