JVC VN-V686U Instructions Manual page 18

Connection/Installation
Mounting the Camera
(continued)
8
Mount the terminal cover
Return the terminal cover that was removed in step
3
to its original position. The direction to pull out
the cables changes according to the mounting
method of the camera.
Pulling out the cables from the side
Pulling out the cables from the top
Note:
● Be sure to mount the terminal cover to prevent
foreign objects or dust from entering.
● When pulling out the cables from the top, make
the fall prevention wire go under the terminal
cover and pull it out together with the other
cables.
● When pulling out the cables from the side,
remove the cable cover of the camera.
Terminal cover
Fall Prevention Wire
(To go under the terminal cov
Terminal
cover
Cable cover
Mounting the ceiling clamping bracket
to the ceiling
1
Secure the ceiling clamping bracket
on the ceiling
● Install such that the DFRONT mark of the
ceiling clamping bracket faces the front.
● Ensure that the connection cables are not
caught in between and secure the ceiling
clamping bracket on the ceiling with 3 screws.
Front of the camera
DFRONT mark
5 mm and below
Note:
● Use M4 fixing screws and bolts.
● Use R4.1 wood screws.
● The length of the screws should be 25 mm and
above.
● Place the product horizontally and install. The
camera will not operate properly if it is slanted.
● The screw head should be 5 mm and below. If
the ceiling structure is metal, image noise may
occur.
:
Memo
● Always use 3 screws and mount securely.
● Tighten the screws again during maintenance
just to be safe.
● The plastic parts on the ceiling fixing holes of
the ceiling clamping bracket act as an insulation
between the ceiling clamping bracket and the
ceiling structure. If the ceiling structure is metal
and insulation is not provided between the
camera and the ceiling structure, image noise
may occur. Be sure to provide insulation.
Screws