Onboard Audio; Kb/Ms Wakeup - AOpen MX3W-V User Manual

Tip: If your system hangs or fails to boot because of over-
clocking, please clear CMOS and the system will go back to
the default setting (233MHz or 350MHz).
Tip: If your system hangs or fails to boot because of over-
clocking, simply use <Home> key to restore to the default
setting. By this smart design, it would be more convenient to
clear CPU frequency setting. For using this function, you just
need to press <Home> key first and then press Power
button at the same time. Note that do not release <Home>
key until POST screen appearing.
2.2.4 Sound
JP12 Sound
1-2 Enabled (default)
2-3 Disabled

2.2.5 KB/MS Wakeup

JP28 KB/MS Wakeup
1-2 Disabled
2-3 Enabled
AWARD BIOS
If you want to install another sound card,
you have to disable the onboard audio by
setting this jumper to Disabled.
JP12
1
2
3
Enabled (default)
This jumper is used to enable or disable
Keyboard/Mouse Power ON function. If you
select Enabled, you may decide the wakeup
mode from BIOS Setup. To implement this
function, the 5V Stand By current must be
greater than 800mA.
Note that only PS/2 mouse supports Wake On
Mouse function.
2-7
JP12
1
2
3
Disabled