Http - Xerox WorkCentre 7232 System Administrator Manual

4 CentreWare Internet Services
POP3 Settings:
• Polling Interval – Enter the interval to check the POP3 server between 1 and 120
6.
Select [Apply] to reflect the new settings.
7.
Enter the user ID and passcode, and then select [OK].
NOTE: The default user ID is "11111" and the default passcode is "x-admin".
8.
When the reboot message appears, select [Reboot Machine].

HTTP

This page allows you to configure the HTTP settings.
NOTE: Some settings on this page will only be available after you restart CentreWare
Internet Services, or after the machine is switched off and on.
1.
At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2.
In the [Properties] frame, select the plus symbol [+] to the left of the [Connectivity]
folder.
3.
Select the plus symbol [+] to the left of the [Protocols] folder.
4.
Select [HTTP].
5.
Set up the following displayed in the frame.
• Connection – Displays whether the protocol is enabled or disabled.
• Physical Connection – Displays "Ethernet". This is a display-only item.
• Keep Alive Timeout – Displays "60 seconds". This is a display-only item.
• Maximum Connections – Enter the maximum number of connections between
• Port Number – Enter the port to be used for HTTP communication.
• Secure HTTP (SSL) – Select whether or not to enable SSL/TLS communication.
• Secure HTTP Port Number – Enter the port number to be used for SSL/TLS
• Connection Time-Out – Allows you to specify the connection time-out period
6.
Select [Apply] to reflect the new settings.
7.
Enter the user ID and passcode and then select [OK].
NOTE: The default user ID is "11111" and the default passcode is "x-admin".
8.
When the reboot message appears, select [Reboot Machine].
62
minutes in 1 minute increments.
1 and 15.
communication.
when transmission fails
Xerox WorkCentre 7232/7242 System Administration Guide