Xerox WorkCentre 7232 System Administrator Manual page 82

5 NetWare
NOTE: Keep the SNMP protocol enabled while you use the machine on the TCP/IP
network.
NOTE: Some of the configuration options for this protocol are only available from
CentreWare Internet Services.
First, enable the NetWare protocol.
1.
Connect the machine to the network.
2.
Press the <Log In/Out> button on the control panel, and then type the Key
Operator login ID to enter the Key Operator mode.
NOTE: The passcode may also be required depending on the machine configuration.
3.
Press the <Machine Status> button on the control panel, and then select the
[Tools] tab on the screen.
4.
Select [System Settings].
5.
Select [Connectivity & Network Setup].
6.
Select [Port Settings].
7.
Select [NetWare], and then [Change Settings].
8.
Select [Port Status], and then [Change Settings].
9.
Select [Enabled], and then [Save].
Next, establish TCP/IP if you use IP Address for a NetWare network.
1.
In [Connectivity & Network Setup], select [Protocol Settings].
2.
Under [TCP/IP - IP Mode], select [IPv4 Mode] or [Dual Stack].
NOTE: [IPv6 Mode] is not available for Netware settings.
3.
Select [IP Address Resolution], and then [Change Settings].
4.
Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP],
[DHCP/Autonet], and [STATIC], and then select [Save].
NOTE: Use the DHCP server together with the Windows Internet Name Server
(WINS) server.
If you selected [STATIC] in step 4, then proceed to step 5 to configure the protocol
settings. Otherwise, proceed to step 11.
5.
Select [IPv4 - IP Address], and then [Change Settings].
6.
Use the keypad on the screen to enter the IP Address for the machine in the
format "xxx.xxx.xxx.xxx". Enter a value (0 to 255) into the highlighted field and
select [Next]. The next 3 digits are highlighted. When you have finished entering
all values, select [Save].
7.
Select [IPv4 – Subnet Mask], and then [Change Settings].
8.
Using the same method as in step 6, enter the Subnet Mask.
9.
Select [IPv4 – Gateway Address], and then [Change Settings].
72 Xerox WorkCentre 7232/7242 System Administration Guide