Toner Replenisher/Drum Dehumidifier - Minolta EP2010 Operator's Manual

2. Toner Replenisher/Drum Dehumidifier

Toner Replenisher
The copier tends to exhaust the supply of toner rapidly when making a number of copies from an
original with dark solid areas such as a photo. As a result, the image density of the copy will
become lighter. In such a case, you can use the Toner Replenisher function to regain the normal
image density quickly.
Press the Auxiliary Toner Replenishing Key.
*This causes the copier to initiate toner replenishing, which lasts for 90 seconds at maximum.
Toner
Drum Dehumidifier
During high humidity periods or when there are sudden rapid changes in humidity (especially
when you are using a heater in winter), condensation *1 could form on the surface of the PC
*2
Drum , resulting in blotchy copies. In such instances, use the Drum Dehumidifier function
to dry the surface of the PC Drum.
*1
Condensation : A phenomenon in which small drops of water are formed on cold surfaces,
such as the surface of the PC Drum.
*2
PC Drum : Functions in the copier as film in a camera.
Press the Drum Dehumidify Key .
*This sets the copier into the Drum Dehumidifier Mode which lasts for 90 seconds.
Drum
Dehumidify
Do not turn the Power Switch OFF or
open the Front Door while the copier
is replenishing toner.
Toner is not replenished if the image
density is sufficiently high
1139O2478A 1139O2482A
1139O2472A
NOTE
Useful Tip
A copy cycle can be initiated even
while the copier is in the Drum
Dehumidifier Mode.
51