Adjust The Volume Of The Different Speakers; Saving Frequently Used Settings (Quick Select Function); Main Zone Settings; Zone2 Settings - Denon AVR-1910 Owner's Manual

ENGLISH
Adjust the volume of the
different speakers
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.

Adjust the volume of the different speakers

1
Press .
FL
C
FR
SW
[
2
ui
Press to select the speaker.
The speaker that can be set switches each
time one of the buttons is pressed.
3
o p
Press to adjust the volume.
b In the case of a subwoofer, reducing
"–12 dB" will change the setting to "OFF" (none).
If headphones are plugged in, the headphones settings screen
appears.
Adjusting the volume of groups of speakers
(Fader Function)
This function lets you adjust (fade) the sound from all the front (Front
speaker / center speaker / Front Height speaker) or rear (Surround speaker /
Surround Back speaker) speakers at once.
1
i
Use or to select "Fader", then select the item
o
to be adjusting using or
2
o p
Press to adjust the volume of the speakers.
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.
0
Saving frequently used settings
(Quick Select Function)
This function allows you to save all the settings shown in step
1. When frequently used settings are saved, they can easily be
set again the next time you want to use them. This function also
allows you to always enjoy the same playback environment.
Channel Volume
• Three sets of settings can be saved.
0.0dB SR 0.0dB
0.0dB SBR 0.0dB
0.0dB SBL 0.0dB

MAIN ZONE settings

0.0dB SL 0.0dB
Fader
Saving the settings
FRONT : REAR
]:CH Sel.
1
Set the items below to the settings you want to save.
Front
q Input source (vpage 37)
w Input Mode (vpage 34)
e Surround Mode (vpage 42)
r A udyssey Settings (MultEQ, Dynamic EQ, Dynamic
Volume) (vpage 46)
t Front Speaker Setup (vpage 27)
y Volume setting (vpage 37)
u Video Select (vpage 34)
the volume when it is at
2
Press and hold the desired
appears on the display.
The current settings will be memorized.
Quick Select 1
Quick Select 2
Quick Select 3
Calling the settings out
p
.
Press the
settings you want to call out are saved.
NOTE
Input sources stored with the quick select function cannot be selected
if they have been deleted at menu "Source Delete" (vpage 30). In
this case, store them again.
Front
until "Memory"
GQuick Select DefaultsH
Input Source Volume
DVD –40 dB
SAT/CBL –40 dB
VCR/iPod –40 dB
Front
at which the
n Naming Quick Select settings
"Quick Select Name" (vpage 31).

ZONE2 settings

It is also possible to save three settings for ZONE2.
Saving the settings
1
Set the remote control unit's
device selector switches as
shown on right.
2
Perform steps 1 and 2 under "MAIN ZONE
settings".

Various memory functions

Personal Memory Plus Function
This function sets the settings (input mode, surround mode, MultEQ,
Dynamic EQ, Dynamic Volume, audio delay etc.) last selected for the
individual input sources.
Last Function Memory
This stores the settings as they were directly before the standby mode
was set.
When the power is turned back on, the settings are restored to as they
were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the power
is turned off or the power cord is disconnected.