Denon AVR-1910 Owner's Manual page 33

Making the audio settings (Audio Setup)
Make settings for audio playback.
Setting items
EXT.IN SW Level
+15dB : This is the recommended level.
Set the playback level of the
+10dB / +5dB / 0dB : Select the level according to the player being used.
analog subwoofer signals
input from the external input
terminals (EXT.IN).
2ch DIRECT/STEREO Setting : Select the method for setting the speakers used in the 2-channel
Make speaker settings for 2- direct and stereo playback modes.
channel mode playback. • Basic : The settings at "Speaker Setup" (vpage 25) are applied.
• Custom : Make separate settings for 2-channel mode.
Front : Set the front speaker size.
• Large : Use of a large speaker that can adequately play back low
frequencies.
• Small : Use of a small speaker that has inadequate playback capacity
for low frequencies.
SW : Set the presence of a subwoofer.
• Yes : Use a subwoofer.
• No : Select when a subwoofer is not connected.
SW Mode : Select low range signal to be reproduced by subwoofer.
• LFE : Add the low frequency signal of the channel for which the speaker
size is set to "Small" to the subwoofer signal and output it.
• LFE+Main : Add the low frequency signal of all channels to the
subwoofer signal and output it.
Crossover : Outputs at below set frequency, each speaker's bass signal
output from the subwoofer.
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz
/ 250Hz
Distance FL / Distance FR : Select the speaker you want to set, and set
the CH Level. Set the value that is closest to the measured distance.
0.0ft ~ 60.0ft (12.0ft) / 0.00m ~ 18.00m (3.6m)
•
CH Level FL/ CH Level FL FR : Select the speaker you want to set, and
set the CH Level. Adjust the level of each channel.
• –12.0dB ~ +12.0dB(0.0dB)
Remote control
operation buttons
Default settings are underlined.
Setting contents
Displaying the menu
:
: Moves the cursor (Up/Down/Left/Right)
Cancel the menu
Setting items
Auto Surround Mode ON : Memorize settings. Most recently stored surround mode is
Make setting for memorizing automatically selected.
surround mode setting for
OFF : Do not memorize settings. Surround mode does not change
each input signal type.
according to input signal.
The auto surround mode function lets you store in the memory the
surround mode last used for playing the four types of input signals
listed below.
q Analog and PCM 2-channel signals
w Dolby Digital and DTS 2-channel signals
e Dolby Digital and DTS multi-channel signals
r Multi-channel signals other than Dolby Digital and DTS (PCM, etc.)
NOTE
When playing in the PURE DIRECT mode, the surround mode does not
change even if the input signal is changed.
EQ Customize Audyssey Byp. L/R / Audyssey Flat / Manual
Set so that unused equalizer
• Used
settings are not displayed
• Not Used
when is used.
NOTE
• Set so that the "Audyssey Byp. L/R" and "Audyssey Flat" settings can be
made when the Audyssey Auto Setup procedure is performed.
• Equalizer settings for which "Not Used" is set with the Quick Select
function cannot be stored and called out.
: Decision the setting
ENGLISH
Making detailed settings (Manual Setup)
Setting contents
2
: Return to previous menu