Adjust The Volume Of The Different Speakers; Saving Frequently Used Settings (Quick Select Function); Various Memory Functions - Denon AVR-590 Owner's Manual

ENGLISH
Adjust the volume of the
different speakers
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.

Adjust the volume of the different speakers

1
Press .
Channel Volume
FL 0.0dB SR
C 0.0dB SBR
FR 0.0dB SBL
SW 0.0dB SL
Fader
FRONT : REAR
[ ]:CH Sel.
2
ui
Press to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
o p
Press to adjust the volume.
b In the case of a subwoofer, reducing
"–12 dB" will change the setting to "OFF" (none).
If headphones are plugged in, the headphones settings screen
appears.
Adjusting the volume of groups of speakers
(Fader Function)
This function lets you adjust (fade) the sound from all the front (Front
speaker / center speaker / Front Height speaker) or rear (Surround speaker /
Surround Back speaker) speakers at once.
1
i
Use or to select "Fader", then select the item to
o p
be adjusting using or
2
o p
Press to adjust the volume of the speakers.
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.

Saving frequently used settings
(Quick Select Function)
This function allows you to save all the settings shown in step
1. When frequently used settings are saved, they can easily be
set again the next time you want to use them. This function also
allows you to always enjoy the same playback environment.
• Three sets of settings can be saved.
Saving the settings
0.0dB
0.0dB 1
Set the items below to the settings you want to save.
0.0dB
0.0dB
q Input source (vpage 34)
w Input Mode (vpage 32)
e Surround Mode (vpage 37)
r A udyssey Settings (MultEQ, Dynamic EQ, Dynamic
Volume) (vpage 41)
t Volume setting (vpage 34)
2
Press and hold the desired
appears on the display.
the volume when it is at
The current settings will be memorized.
Quick Select 1
Quick Select 2
Quick Select 3
Calling the settings out
Press the
want to call out are saved.
NOTE
.
Input sources stored with the quick select function cannot be selected
if they have been deleted at menu "Source Delete" (vpage 28). In
this case, store them again.
n Naming Quick Select settings
"Quick Select Name" (vpage 29).
until "Memory"
GQuick Select DefaultsH
Input Source Volume
DVD –40 dB
SAT/CBL –40 dB
VCR/iPod –40 dB
at which the settings you

Various memory functions

Personal Memory Plus Function
This function sets the settings (input mode, surround mode, HDMI
output mode, MultEQ, Dynamic EQ, Dynamic Volume, audio delay
etc.) last selected for the individual input sources.
The surround parameters, tone settings and the volumes of the
different speakers are stored for the individual surround modes.
Last Function Memory
This stores the settings as they were directly before the standby mode
was set.
When the power is turned back on, the settings are restored to as they
were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the power
is turned off or the power cord is disconnected.