Am Frequency Step Setup (Not North American Models) - Integra DTR-7.9 Instruction Manual

First Time Setup—Continued
AM Frequency Step Setup
(not North American models)
For AM tuning to work properly, you must specify the
AM frequency step used in your area. Note that when
this setting is changed, all radio presets are deleted.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ] but-
tons to select "7. Hardware
Setup", and then press [Enter].
The "Hardware Setup" menu appears.
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
6. Network
3
Use the Up and Down [ ]/[ ] but-
tons to select "3. Tuner", and
then press [Enter].
The "Tuner" menu appears.
7–3. Tuner
AM Frequency Step
4 Use the Left and Right [ ]/[ ]
buttons to select:
10kHz: Select if 10 kHz steps are
used in your area.
9kHz: Select if 9 kHz steps are used
in your area.
5
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
9kHz
Press the [Setup] button.
The setup menu closes.
47