Integra DTR-7.9 Instruction Manual page 64

Listening to the Radio—Continued
Enter
Setup
Positioning the XM Mini-Tuner System
You can check the signal strength of the XM radio signal
and adjust the position of the XM Mini-Tuner System
accordingly.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ] but-
tons to select "7. Hardware Setup",
and then press [Enter] button.
The Hardware Setup menu appears.
3
Use the Up and Down [ ]/[ ] but-
tons to select "3. Tuner", and
then press [Enter] button.
The Tuner screen appears.
64
Receiver
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
6. Network
7–3. Tuner
SAT Radio Mode XM
Antenna Aiming
4
Use the Left and Right [ ]/[ ]
buttons to select "XM".
Use the Up and Down [ ]/[ ] but-
tons to select "Antenna Aiming",
and then press [Enter].
The "Antenna Aiming" screen appears.
Note:
If the SAT Radio Mode is set to "None"
(see page 60), the "Antenna Aiming"
item is not available.
5
Position the XM Mini-Tuner
Antenna so that as many bars as
possible (up to 3) appear on the
XM Satellite signal strength
meter.
The best signal is achieved when the
antenna is pointing to the southern sky
through an unobstructed window.
7–3. Tuner
XM Antenna Aiming
Satellite
If you cannot receive a satellite signal,
position the XM Mini-Tuner System so
that as many bars as possible (up to 3)
appear on the XM Terrestrial signal
strength meter.
Notes:
• So long as the signal strength is good, you can enjoy
XM Radio by using either satellite or terrestrial recep-
tion.
• Terrestrial signals are only available in certain areas.
• The XM information is only displayed when the SAT
Radio Mode is set to "XM" or "XM/SIRIUS" (see
page 60).
• If you're using both XM Satellite Radio and SIRIUS
Satellite Radio and the SAT Radio Mode is set to
"XM/SIRIUS" (see page 60), signal strength meters
for both systems appear on the same screen.
Terrestrial