Muting The Av Receiver; Using The Sleep Timer; Using Headphones - Integra DTR-7.9 Instruction Manual

Basic Operations—Continued

Muting the AV receiver

You can temporarily mute the output of the AV receiver.
Press the [Receiver] button, and
then press the [Muting] button.
The output is muted and the MUTING
indicator flashes on the display, as
shown.
To unmute the AV receiver, press the
[Muting] button again, or adjust the
volume.
The Mute function is cancelled when
the AV receiver is set to Standby.
Tip:
You can specify how much the output is muted with the
"Muting Level" setting (see page 106).
56

Using the Sleep Timer

Press
With the sleep timer, you can set the AV receiver to turn
[Receiver]
off automatically after a specified period.
first
Muting
If you need to cancel the sleep timer, press the [Sleep]
button repeatedly until the SLEEP indicator disappears.
To check the time remaining until the AV receiver sleeps,
press the [Sleep] button. Note that if you press the [Sleep]
button while the sleep time is being displayed, you'll
Sleep
shorten the sleep time by 10 minutes.

Using Headphones

You can connect a pair of stereo headphones (1/4-inch
phone plug) to the AV receiver's Phones jack for private
listening, as shown.
Notes:
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the Phones
jack, the speakers are turned off and the Headphone
indicator lights up. (The Powered Zone 2 speakers are
not turned off.)
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it's already set to Stereo,
Mono, or Direct.
• Only the Stereo, Direct, and Mono listening modes
can be used with headphones (the listening modes
available also depend on the currently selected input
source).
• When the multichannel input is used, only the front
left and right audio can be heard in the headphones.
Press the [Receiver] button, and
then press the [Sleep] button
repeatedly to select the required
sleep time.
The sleep time can be set from 90 to 10
minutes in 10 minute steps.
The Sleep indicator appears on the dis-
play when the sleep timer has been set.
The specified sleep time appears on the
display for about five seconds, then the
previous display reappears.