Setting The Powered Zone 2 - Integra DTR-7.9 Instruction Manual

Zone 2—Continued

Setting the Powered Zone 2

If you've connected your Zone 2 speakers to the AV
receiver, as explained in "Connecting Your Zone 2
Speakers Directly to the AV receiver" on page 114, you
must set the "Powered Zone2" setting to "Act" (Acti-
vated).
1 Press the [Receiver] button fol-
lowed by the [Setup] button.
Remote
The main menu appears onscreen.
controller
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ] but-
tons to select "7. Hardware
Setup", and then press [Enter].
The "Hardware Setup" menu appears.
3 Use the Up and Down [ ]/[ ] but-
tons to select "2. Zone2", and
then press [Enter].
The "Zone2" menu appears.
116
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
6. Network
7–2. Zone2
Powered Zone2 Not Act
Zone2 Out Fixed
4 Use the Up and Down [ ]/[ ] but-
tons to select "Powered Zone2",
and use the Left and Right [ ]/
[ ] buttons to select:
Not Act:
Zone 2 L/R speaker terminals not
activated (Powered Zone 2 dis-
abled).
Act:
Zone 2 L/R speaker terminals acti-
vated (Powered Zone 2 enabled).
5 Press the [Setup] button.
The setup menu closes.
Notes:
• When "Act" is selected and Zone 2 turned on, the
Zone 2 speakers connected to the Zone 2 L/R speaker
terminals output sound, but the surround back speak-
ers connected to the SURR BACK L/R speaker termi-
nals do not. When "Act" is selected and Zone 2 turned
off, the surround back speakers output sound as nor-
mal.
• Powered Zone2 cannot be used if "Speakers Type" is
set to "Bi-Amp" (see page 45).
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.