4.16 USB board
Removing the USB board
To remove the USB board, follow the steps below and refer to Figure 4-25.
1. Remove the following screw and lift up the USB board to the left above.
• M2.5×6S Tapping screw
2. Disconnect the USB cable from the connector CN4622 on the USB board.
3. Disconnect the USB cable from the connector CN4610 on the system board and take
it out.
CN4610
TECRA S3 Maintenance Manual (960-532)
×1
M2.5×6S Tapping
Figure 4-25 Removing the USB board
USB board
CN4622
USB cable
[CONFIDENTIAL]
4-39