Toshiba Tecra S3 Maintenance Manual page 264

Installing the Slim select bay module
To install the slim select bay module, follow the steps below and refer to Figure 4-8 and 4-9.
1. Install the connector cover holder to the optical drive assembly and secure it with
the following screws.
• M2×6S
• M2×22S BIND screw
2. Install the connector cover to the optical drive assembly and secure it with the
following screw.
• M2×3S
3. Install the connector cover and connector to the optical drive assembly and secure it
with the following screws.
• M2×6S
4. Insert the slim select bay module into the computer to connect it to the connector on
the system board. Press to ensure a firm connection.
5. Remove the following screw from the screw hole. Then secure the latch with the
removed screw. (The slim select bay is locked.)
• M2.5×4B FLAT HEAD screw
TECRA S3 Maintenance Manual (960-532)
BIND screw
S-FLAT HEAD screw
BIND screw
×1
×1
×1
×2
×1
[CONFIDENTIAL] 4-21