Display Assembly - Toshiba Tecra S3 Maintenance Manual

4 Replacement Procedures

4.13 Display assembly

Removing the Display assembly
To remove the display assembly, follow the steps below and refer to Figure 4-18 to 4-20.
1. Peel off the insulator and disconnect the finger print sensor cable from the
connector CN9700 on the system board.
2. Disconnect the speaker cable from the connector CN6170 on the system board.
3. Turn up the black tape and disconnect the LCD cable from the connector CN5500
on the system board.
4. Remove the following screws.
• M2.5×8B
• M2×6S
M2.5×8B FLAT HEAD
TECRA S3 Maintenance Manual (960-532)
FLAT HEAD screw
BIND screw
CN5500 CN6170
M2×6S BIND
Figure 4-18 Removing the display assembly (1)
×1
×1
Insulator
[CONFIDENTIAL]
CN9700
4-31