Multitech FaxFinder FF440 Administrator's Manual page 27

Field
Fax Direction Specify if this modem is for inbound faxes only, outbound faxes only, or both. This setting
should match the setting of the analog line/equipment connected to this port. If the
modem is set to outbound, but the PBX/Telco line connected to it is set to inbound,
FaxFinder will not answer inbound calls.
Routing If you selected a vendor pre-defined routing code, it displays in this field. If you selected
Definition User Defined for Routing, enter your own formula/definition in this field. Routing Definition
identifies code elements sent by the PBX so that FaxFinder can mask information it doesn't
need and identify the extension number it does need.
Key
Description Explains the current mode code, if any, in the Routing Definition field.
Error Select On to use T.30 error correction with this modem or Off to disable it. Default is On.
Correction
Max Baud Rate Select the maximum connection (baud) rate that allowed on the modem. Default is 14400.
Smart Dial Select On to enable Smart Dial or Off to disable it. When Smart Dial is enabled, the modem
waits to detect a dial tone before dialing.
Dial Prefix This is a global setting applied to all outbound calls made from this modem, for example, 9
to dial an outside line. Any value entered here is automatically the first number dialed for all
outbound faxes, regardless of how a fax is submitted.
Tone Dial Select On for tone dialing or Off for pulse dialing. Default is On.
Init String Use this field to define additional AT modem commends needed for your faxing
environment. AT commands entered here will be issued to this modem before every call on
this port, inbound or outbound.
Fax Debugging If a communication error occurs when FaxFinder attempts to send or receive a fax,
FaxFinder creates a modem log file. This is available through the FaxFinder Web
Management Log menu. When you enable Fax Debugging, the log file provides more details
about the fax call.
Select On if you want to log fax debugging information or Off if you do not.
Note:
FaxFinder x40 Administrator Guide
●
n is the variable number for each definition
●
For Call Type, Calling Number, and Internal Code, replace n with the
number of digits that you want masked or ignored.
●
For Extension digits, replace n with the number of extension digits used to
route inbound faxes to recipients.
●
If you are using a predefined mode code that use $x? as the Extension
Digits variable, use the Max DTMF Digits field to define the number of DID
extension digits.
Multi-Tech recommends that you turn this on as needed to collect data for
troubleshooting and turn it off when you have the more detailed log file.
Chapter 3 – Basic FaxFinder Configuration
Description
27